I know that's a lot of info - hope you find it all helpful.Buy New Wifi Connection for Home – Airtel Xstream Fiber (A lot of mesh systems like Nest Wifi or TP-Link Deco will support connecting directly to the WAN and functioning as a router, so you don't necessarily need a separate router if you purchase one of these mesh systems.) Connect the mesh to the router in bridge mode, rather than allowing the mesh to function as a router. :-)īTW, if you get a mesh, you will probably just want to disable the wifi portion of the router, and let the mesh handle the wifi for you. Most folks probably don't need anything quite this fancy. It's a pretty critical resource for us all at home right now, though, so I went a little extreme. So ideally, we will almost never be without working Internet. (Two adults who work from home plus three teeangers who study, watch tons of Youtube, and play online games with their nstantly.) I actually temporarily retained our old Comcast service as a backup should Ziply ever go down, and configured my pfSense router with automatic failover to Comcast in that case. You don't need a setup nearly as fancy as mine with pfSense and the mesh, although we've got a really crazy power user setup here. I think my R6700 cost right around $100 or so. Though, you don't have to spend a fortune. The ones you find toward the upper end of your stated budget will probably give you better performance with the service. In other words, the bottleneck would be at your cheapo router, and not the ONT from Ziply. However, if you cheap out on the router, it may not give you all the performance that the service is capable of. So really, any OTS router you buy from Amazon, Newegg, Best Buy, or wherever should technically do the trick. You could either plug it into Ziply's WAN drop in your wall, or to the WAN port of a Comcast cable modem, and the router would work the same either way. The router doesn't really care where the IP address comes from - it doesn't need to know that. Think of it this way: the cable modem or ONT provides an interface to allow your router to connect upstream and get a WAN IP address. I'm not sure that you could plug Comcast's cable modem/router combo into your Ziply WAN port and expect it to work). This could be the same router you would hook up to a cable modem, as long as the cable modem part is not integrated into the router. The cable will go from the RJ-45 jack in the wall to your router's WAN port. You then just need a router that will connect to the primary drop via Cat-5/5e/6 Ethernet cable. Often it will terminate in a room in your house nearest to where the ONT is located, but you can opt to pay Ziply or an outside contractor (or do it yourself, if you know what you are doing) to run a line from the ONT to whichever room in your house you want the primary drop to terminate. This is the primary drop into your house. This will typically be something like Cat-5/5e/6 twisted pair. The ONT is essentially analogous to a cable modem from the cable company, except that it is permanently attached to the side of your home.įrom the ONT, there should be a line that comes into your home which will terminate at an RJ-45 port. If you get the Ziply TV service as part of your package, then the Ziply TV boxes need MoCA - otherwise, MoCA is unnecessary, and everything just runs off of Ethernet. The ONT converts fiber signals from Ziply upstream to Ethernet and MoCA (coax). The ONT is provided by Ziply, it sits (usually) on the outside of your home - often in place of where the old telco interface box used to sit. Tried to respond to your other comment, but it disappeared! Here is what I was going to say:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |